The HWIL RF Engineer (E4) will analyze, design, test, and troubleshoot RF systems and subsystems for Hardware-in-the-Loop (HWIL) test sets. This staff-level engineer will independently guide assigned RF capabilities from requirements and architecture through design, integration, and verification. Working without day-to-day technical direction, the engineer will develop innovative solutions to complex RF problems, make system-level design tradeoffs, and collaborate with electrical, software, firmware, systems, and test engineers to deliver reliable, well-documented HWIL test capabilities.
Core Responsibilities
• Translate HWIL test objectives and system requirements into RF subsystem requirements, architectures, interface definitions, and verification approaches.
• Analyze RF signal chains and develop performance budgets addressing gain, loss, noise, linearity, dynamic range, isolation, and frequency coverage.
• Design and integrate RF assemblies and signal paths, including frequency conversion, filtering, amplification, switching, and local oscillator distribution as required.
• Evaluate RF design tradeoffs and component selections against system performance, interface, integration, and maintainability requirements.
• Develop RF test plans and procedures; configure and operate vector network analyzers, spectrum analyzers, signal generators, power meters, and related instrumentation.
• Characterize and verify RF performance, assess measurement limitations, and establish appropriate calibration and correction methods for test-set signal paths.
• Lead troubleshooting and root-cause analysis of complex RF failures, performance discrepancies, and integration issues; implement and verify corrective actions.
• Collaborate with firmware and software engineers on RFSoC-based test-set interfaces, converter operating parameters, and end-to-end RF performance.
• Produce and maintain RF analyses, block diagrams, interface documentation, design records, test procedures, and verification reports under configuration control.